OHAUS SD Série Mode D'emploi page 10

EN-4 SD SERIES BENCH SCALE
• Bracket Wall Mounting/Table Mounting:
Attach the two mountng brackets as shown n Fgure 4. Poston the
Indcator where desred on the wall or table. Install 2 screws (not suppled)
nto the ends of each bracket to secure them to the surface. When mountng
to a wall wthout sold backng, use approprate anchorng hardware.
MOUNTING NOTES:
1. When attachng brackets: Insert round pns nto holes at bottom of
Indcator, slde each bracket back to lock n place.
2. Mountng brackets may be attached n two dfferent orentatons to provde
optmum vewng angle.
3. Some mountng postons may requre that the brackets be attached to the
work surface before beng attached to the ndcator.
Fgure 4. Bracket Wall & Table Mount Arrangements.
Fgure 3. Drect Wall Mount Arrangement.
120mm / 4.72"
120mm / 4.72"