Operation - oneConcept 10029282 Mode D'emploi

Wall mounting
1. Find and mark two circles on the wall where the fan will be mounted. The circles need to be 4 3/4" apart
from center to center. The circle size should be 3/8" in diameter.
2. Drill #8 screws into the wall (screws are not included). Use drywall anchors if a stud is not available.
3. Leave about 3/8" of each screw exposed.
4. Line up the opening at the base of the fan with the screws and hang the fan on the wall.
Front controls
1. Please ensure the fan if OFF (in the O position) and placed on a dry level surface.
2. Plug the power cord into a polarized 240volt AC wall outlet.
3. Turn the knob on the front of the fan upwards for Oscillation
Mode, or downwards for Non-Oscillation Mode.
4. The following are the air speeds for both Oscillation and
Non Oscillation Modes
a. 0= off
b. 1= low
c. 2= medium
d. 3= high
5. To turn the fan Off, move the knob back to the O position.
Do not attempt to force or impede the fan's oscillation. Doing so will damage the fan and void the
warranty. If when turned off, the fan is not in its flush position, simply turn the fan on and wait for it
to return to its flush position, then turn off.
Adjusting the vertical angle:
1. In addition to the Oscillating feature, the Air Circulator can also be adjusted from Oto 90 degrees vertically.
2. To adjust the vertical angle of airflow, first ensure that the fan is Off (knob should be pointed to the O
position).
3. Gently hold the base down with one hand, and with the hand tilt the fan upwards to your desired position.
Note: do not hang or mount this fan on ceiling. Do not operating this fan in oscill atoin mode when
it is wall-mounted.

Operation

11