Assembly; Use And Operation - oneConcept 10031517 Mode D'emploi

1. Snap the two parts of the base together and secure with the three screws using a Phillips
(cross-head) screwdriver.
2. Pass the Power Cord through the center hole of the base, after snapping the two pieces
together (The back piece is the one with the power cord securing channel).
3. Line up the Tower fan on the base. Fix with the 3 long screws, with a Phillips (Cross-
Head) screwdriver.
Remote Control
1. Install one „mercury" (not included) battery.
2. The Remote Control Power button is labeled as such. All the functions performed with
the Remote Control work identically to the Manual Controls.
The FAN may be operated by the manual controls located on the FAN or by your remote
control.
Place the FAN on a stable flat surface. Plug the cord set into a 230V~A.C. electrical outlet.

Assembly

Use and Operation

9