AUDIOLINE Watch&Care NFS-100 Mode D'emploi page 29

NOTE
• Brush any hair aside if it covers the ear and wait approxi-
mately 30 seconds for a more accurate measurement.
Gently place the NFS-100 on the neck directly behind the
ear lobe and scan following the directions of the arrows
over approximately 1 ~ 2 cm of skin as illustrated for 3
seconds.
• You should slide the product until you hear the 'beep"
sound, which indicates the end of the measurement. It can
then be removed from the skin.
• Normally, the artery behind the ear lobe does not provide a
sufficiently accurate reading. However, in the case of a fall
in skin temperature due to sweating, taking the temperatu-
re from behind the ear lobe may give a more accurate rea-
ding.
6. You will hear beeping sounds three times
per second, a 'bi' sound twice and a
"beep" sound when the measurement is
finished. The total measurement takes 3
seconds.
7. Read the temperature on the display.
8. A new measurement can be taken after
the ready symbol ( __._ ) is displayed on
the LCD screen.
9. Automatically shuts off after one minute
of non-use.
• If there is perspiration on the forehead,
take the temperature from behind the
ear lobe. In this case, disregard point
number 5. All of the other points still
apply.
How to use
GB
27