Foster 7371/300 Mode D'emploi page 11

A. ON/OFF key > switch the appliance on
and off
B. Control Lock key > activate control panel
lock /child lock
C. Cooking Zone Plus key > increase power
level of cooking zone
D. Cooking Zone Minus key > reduce po-
wer level of cooking zone
E. Cooking Zone Display > display power
level
F. Timer Display > display timer countdown
G. Timer Plus key > increase timer value
H. Timer Minus key > decrease timer value
I . Power Boost > Fast heating
SWITCHING THE APPLIANCE ON
On commissioning, the appliance will be in
the safety position, i.e. control lock is active
and the key is illuminated.
In order to use the appliance the safety fun-
ction must be deactivated by pressing the
key until the indicator light switches off.
Press key to switch the top on. All the L
displays relative to the cooking zones switch
on in the stand-by position (Fig.9). The
control unit remains active for 10 seconds. If
within this time no cooking zone is selected,
the electronic device returns automatically
to the OFF position and the above described
operation must be repeated to switch the
cooking top on again.
SWITCHING THE COOKING AREA ON
Select the desired cooking zone and press
one of the keys. Press key
position 9 (max. power) or key
position 1 (min. power). Once this operation
has been completed you can adjust the tem-
perature with the
the single cooking zone can be adjusted in 9
different positions and will be shown on the
relative luminous display E with a number
from "1 to 9".
RESIDUAL HEAT
If the temperature of the cooking zone
is still high (over 50°) after it has been
switched off, the relative display will indicate
the symbol (residual heat). The symbol
will only switch off when the burn risk in no
longer present.
to go to
to go to
or keys. The power of
POT DETECTION
If the symbol should appear on one of the
cooking area displays, it means that:
1) The recipient being used is not suitable
for induction cooking.
2) The diameter of the recipient used is infe-
rior to that allowed by the appliance. (Fig.11)
3) No recipient is present.
TIMER
This function allows establishing the time
(from 1 to 99 minutes) for automatically
switching the selected cooking zone off.
To enable the timer, press either
H key local timer. The display E of all cooking
zones symbol
required cooking zone with one of the but-
tons, ; or
B
of the active zone, will indicate the selection.
Set the power of the area between 1 and 9
with the same keys
previously selected button
point of time off required with the keys of
G or H area timer. The selection will be
confirmed after a few seconds, with audible
beeps. The countdown will be displayed on
F. An acoustic signal will indicate the timer
expiration and the relative cooking zone will
automatically switch off. Press any of the
keys to stop the acoustic signal.
To disable the timer, press the button
the timer.
QUICK HEATING / POWER BOOST
To disable the timer, press the button and
the timer.
The use of this function is recommended for
heating a large quantity of liquid in a very
short time (i.e. water for cooking pasta) or
other dishes. To activate this feature select
the button in the area of cooking time. An
B
acoustic signal will be emitted and a symbol
will be visualised on the display E relative
to the area. It can simultaneously activate
multiple booster.
CONTROL PANEL LOCK
It is possible to block the controls to prevent
the risk of unintentional modification of the
settings (children, cleaning etc.). By pres-
11
appears flashing. Select the
. An LED next to the diplay
or if you have not
. Set at this
B
G or
and