Depaepe Telecom HD 2000 URGENCE Notice D'utilisation page 20

Mode 1- HD2000 Urgence 1 programming and
Urgence à clavier (Automatic off-hook dialling):
1) Make sure HD2000 Urgence is connected to the line.
2) Lift the handset.
3) Depress "PGR" key located on the small keypad
(Located at the back of the unit).
A "beep" sound should be heard through the receiver.
4) Depress "P" (Pause) key located on the small
keypad.
A "beep" sound should be heard through the receiver.
5) Dial the telephone number to store including *, # or
"Pause" if needed (22 digits maxi).
6) Press "MX" key.
A double "beep" sound confirms the right storage.
7) Replace the handset on hook.
NOTE: In case of wrong operation, a long "beep"
sound is emitted. Replace the handset on hook and start
again from the beginning.
NOTE: To erase a number stored in memory, proceed
from 1 to 4, skip section 5 (Do not enter any digit) and
terminate as in 6 and 7.
NOTE: HD2000 Urgence 1 and Urgence à clavier
factory settings come with "Urgence" mode. In case of
wrong operation, see « LIST OF SETTINGS » pages
24-25 and check that "Urgence" mode is selected.
Setting access code :
Setting choice
20
04
Urgency:1