Switching On - Videotec ULISSE NETCAM Manuel D'instructions

8 Switching on

Make sure that the unit and other
components of the installation are closed
so that it is impossible to come into contact
with live parts.
During normal operation the surface of the
illuminator can reach high temperatures.
Do not, therefore, allow direct contact
and position the appliance where it is
inaccessible to unauthorised persons.
before touching switch off the illuminator
and allow to cool for a minimum period of
10 minutes.
Do not stay in the vicinity of the device
when it is powered. Always disconnect the
power supply before working on the device.
Make sure that all parts are fastened down
firmly and safely.
The automatic pre-heating (de-ice) process
could be started whenever the device is
switched on and the air temperature is
below 0°C. This process is used to ensure
that the device works properly even at
low temperatures. The duration ranges
between 60 and 105 minutes, depending
on conditions.
The unit is switched on by simply connecting the
power supply. To switch off the unit disconnect the
power.
29