Connection Of The Camera And Motorised Lens; Motorised Lens Ptz Board; Connector For Camera/Motorised Lenses - Videotec ULISSE NETCAM Manuel D'instructions

7.1.3 Connection of the camera and
motorised lens

7.1.3.1 Motorised lens PTZ board

The following is a description of the electronics board
inside the housing, which controls all functions of the
motorised lens.
MOTORISED LENS PTZ bOARD
Terminal Description
CN1 Not used.
CN2 Motorised lens motor control
connector
CN3 Motorised lens potentiometer
connector
CN6 Not used.
CN7 Camera power supply, additional
lines
Tab. 1
CN3
CN2
Fig. 11
16
CN6
CN7
CN1
7.1.3.2 Connector for camera/motorised
lenses
All connections illustrated below should
be made only and exclusively by expert
installers who should comply with all the
wiring and power supply specifications for
the devices.
The electronics board is designed to control cameras
with motorised lenses (Focus, Iris, Zoom), which
may or may not have potentiometers to control the
position reached.
Before making the connections make sure that the
voltages supplied by the board fall within the limits
allowed for the apparatus.

CONNECTOR FOR CAMERA/MOTORISED LENSES

Camera power supply
Lens potentiometer power
supply
Lens motor power supply
Tab. 2
To power the camera perform the connections as
shown in the figure.
+12V GND
Fig. 12 CN7.
+12V, 800mA max
+5V, 15mA max
6-15V (adjustable), 200mA
max (Focus+ Zoom+Iris)
+12V
GND
A
B
F1
F2