Invacare Medley Ergo Manuel D'utilisation page 19

3) The upper side rail bar is installed according to illustration G.
4) The gliding system in the opposite end are installed onto the upper side
rail bar according to illustration H.
5) The side rail bar is raised until an audible click can be heard.
Please be sure, that the gliding system has engaged properly into the first
hole. (see illustration F and I).
6) The lower pawl is unfolded and the lower side rail bar is installed onto
the pawl according to illustration E and J.
7) The lower pawl in the opposite end unfolded (see illustration E)
and the lower side rail bar is then installed onto the lower pawl.
Again, please ensure that pawls and gliders are completely engaged.
(See illustration K).
8) The locking finger screws are installed and tightened.
9) On the Medley Ergo low version, please set one warning sticker on
each end of the lower pawls of full length side rails.
The 4 stickers are put in the bed ends packaging.
When lowering the side rails, there is a risk of entrapment between side rails and mattress support.
There is a risk entrapment on assembly and operation of the side rails.
There is a risk of foot crushing the floor and the lower pawl of the side rails when the mastress
support and the side rails are in lower position.
G
I
CLICK!
K
17
H
J
L