Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER INTERFACE
The standard user interface configuration of the controller consists of the
membrane and the LCD display. The membrane consists of five command
keys (Start, Stop, Load, Unload, and Reset), four navigation keys (Up, Right,
Left and Down), and an Edit mode selection key (Enter). These keys, in
conjunction with the graphics display and the LED icons, make up the user
interface to the compressor.
Figure 4: Xe-70M
LED STATUS ICONS
Three LED icons are used to indicate the current status of the control system
from a distance and are located on the upper left side of the user interface.
Table 2: Xe-70M LED Status Icons
Icon
Name
Function
OK
Illuminates when no Warnings or Trips are sensed.
Can be in a Ready or Not Ready state. This icon will
flash when the machine is Running Unloaded.
Alert
Illuminates when a Warning (flashes) or Trip
(constant ON) is sensed. Can be in a Ready
(Warning) or Tripped state.
Auto
Illuminates when the compressor stops in auto
restart.
COMMAND KEYS
These keys command the controller to perform actions as specified in the
following table. When any of these keys are pressed the action below will be
initiated and logged in the event log.
Table 3: Xe-70M Command Keys
Icon
Name
Function
Puts the compressor into the selected mode of
Load
operation. Unit will load if the pressure conditions
are right.
Puts the compressor into an unloaded state. Unit
Unload
will run unloaded indefinitely.
Clears Warnings and Trips once the fault condition
Reset
is corrected.
Start
Starts the compressor.
Stops the compressor. This button should be
Stop
pressed instead of the Emergency Stop for normal
stopping operation.
80448483 Rev.B
RELEASED 16/Dec/2014 10:49:53 GMT
oPERATING INSTRUCTIoNS (XE-70M CoNTRoLLER)
Icon
Name
Function
Toggles the display between the Navigation mode
Enter
and the Edit mode.
The Load and Unload keys are not used on the variable speed
compressors��
NAVIGATION KEYS
There are four navigation keys (UP, RIGHT, DOWN and LEFT). While the ENTER
key is not considered a navigation key, it is used in conjunction with the
navigation keys to make or confirm a selection.
Figure 5 : Navigation Keys
The navigation keys roll over. Pressing one of the navigation keys will lead
the user down a navigation path. Each time the key is pressed, another step
in the path is taken. Once the end of a navigation path is reached, pressing
the key one more time will bring the user back to the beginning of the path.
Pressing the opposite key will move the user through the navigation path in
the opposite direction. Once the beginning is reached, pressing the opposite
key will take the user to the end of the path.
DISPLAY LAYOUT
Figure 6 : Display Layout
Table 4 : Display Layout
Key
Name
Description
A
Folder Bar
Uses tabs to graphically identify each folder.
B
Title Bar
Identifies current folder and page (underlined).
C
Page Content
Content of the current page.
D
Dashboard
Displays system status.
NOTICE
A
B
C
D
EN
EN-9
Publicité
Chapitres
Table des Matières
