Publicité
Les langues disponibles
Les langues disponibles
Quick release fastener
ASSEMBLY TO THE TOWBAR
A
Fastening bolt
B
Adjustment screw
C
Borehole for the padlock
Ensure that the towbar ball is undamaged, clean and free of grease!
The bolt lever needs to be pulled back; to do this you will need to pull the fastening bolt outwards and turn it. The pre-assembled rear
carrier is placed on the towbar from above. Hold the carrier horizontally with one hand and use your free hand to switch over the bolt
lever. If the rear carrier is still not rmly in place on the towbar, you will need to move the bolt lever back again and turn the adjustment
screw at the side a little and then secure again (see photo 2). Then turn the fastening bolt until it clicks into place (see photo 3). The rear
carrier needs to be secured with the mounted fastening bolt. The supplied padlock should be used to additionally secure the carrier and
also prevents the carrier from being stolen. The manufacturer and the dealer will not be liable for damage or injury caused by incorrect
assembly or improper use. The product has been tested with regard to the safety and attachments and achieved good results even
under extreme conditions. Therefore we can rule out any malfunctions if the product is assembled properly.
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
2
Photo 2
B B
+49 (0)202 42 92 83 0
+49 (0)202 42 92 83 160
Photo 1
A
A
C
B
Photo 3
info@eal-vertrieb.com
www.eal-vertrieb.com
Publicité
