IFM Electronic ASinterface AC5210 Notice De Montage page 6

Important:
Both slaves can be assigned any A/B addresses (e.g. 3A/6A or 9A/25B
etc.). No address can be assigned doubly (e.g. 3A/3A or 9B/9B etc.).
Restore the factory setting (address both slaves to 0)
Using the addressing unit AC1144 the factory setting of the module is
restored by writing a 0 to ID1 of the second slave (factory setting ID1
= 2) by the internal software.
If a slave with the ID code "A" (option of extended addressing mode)
is connected to a master of the first generation (version 2.0), the para-
meter P3 must be 1 and the output bit D3 = 0*. The output bit D3
must not be used.
If a slave with the ID code "A" (option of extended addressing mode)
is connected to a master of the first generation (version 2.0), an
address between 1A and 31A must be assigned to this slave.
AC5210
8 inputs / AS-i profile 2x S-0.A.E / extended addressing mode: yes
Data bit
Input
Socket
I-1/2
L-
(I-3/4)
3
2
I2,I4...
6
D0
1
I-1/2
Y-circuit
inputs
I1,I3...
4
1
L+
L- I2,I4...
3 4
2 1
L+
D1
2
I-1/2 I-2
I-2
(I-4)
* default setting
D2
3
I-3/4 I-3/4 I-4
D3
4