Paoli HURRICANE Manuel D'utilisation Et D'entretien page 10

Accessories being operated.
and/or accessories of the tool which are moving
or working.
Pay attention.
Always pay attention to what are
you doing. Proceed with care. Do not work when
you are tired.
Look after the tools.
Keep them clean and in good
condition so that better results may be obtained
safely. Never remove protection or silencers from
the tool. Follow instructions for maintenance and
for replacing the accessories.
Use and assembly of the accessories.
be done according to the machine instructions
manual. The use of accessories or assembly other
than those recommended may cause personal harm.
Switch off the power supply.
and before performing calibration, maintenance or
replacement operations on the accessories such
as impact sockets, etc., you are recommended to
switch of the power supply to the tool.
Remove the service keys.
always check that the service or adjusting key has
been removed.
Check damaged parts.
received, check that the packaging is intact and
there are no signs of knocks or tampering. Before
LIST OF RESIDUAL RISKS
⚪ Moving parts
⚪ Rotating elements
⚪ Parts with edge
⚪ High pressure
⚪ High temperature parts
⚪ Noise during the use
PACKAGE
The tool is delivered inside a carton box,
protected with anti-vibration material.
Together with the impact wrench inside the
box, you will find the manual of use and
ITALIANO ENGLISH
10
Do not touch parts
This should
After each work session
Before using the tools,
When the goods are
using the tool, carefully check that the safety
device and other parts are in perfect working
conditions. Check that the moving parts are not
damaged, that they are free to move, and check
any other conditions that could limit the operation
of the tool. A damaged protective device or
other component must be replaced or repaired
by an authorised Servile Centre unless otherwise
indicated in this manual.
The tool does not emit non-ionizing radiation.
IMPORTANT.
The use of accessories and spare
parts other than those recommended in this
manual may cause personal harm.
Do not alter any element of the machine
remove protective or safety devices, or elements for
checking the outgoing air flow (filters, deflectors,
etc.) without explicit authorisation from PAOLI.
Stop work
immediately should vibrations or
strange noises occur, or if the tool starts operating
differently.
The tool should be repaired by a qualified
personnel.
This compressed air tool complies
with current safety regulations. Repairs must be
done by qualified personnel, using original spare
parts, otherwise serious harm may be caused to
the operator.
⚪ Vibrations transmitted to the hand-arm
⚪ Materials or substances
⚪ Low visibility
⚪ Low-light
⚪ Ambient temperature
⚪ Repetitive action + noise + environmental
high-temperature
maintenance, the declaration of conformity,
other accessories and lubricants indicated in
this manual of use and maintenance.
or