INSTALLING THE WALL NICHE IN CONCRETE SHUTTERED POOLS
•
Installation (picture number 1a ABS version)
Position first stage wall and wall components flush with structural concrete.
Remove protective covers only when ready to lay tiles / mosaics. In the case of a concrete/liner pool first stage components may
project in order to compensate for cement render or liner insulation thickness. Locate the pneumatic switch housing in a conveni-
ent position 15-20 cm below water level. It is advisable to make provision for protecting the pneumatic tube (PVC 2/4 dia.) and air
inlet tubes (PVC 12/21 dia.) by placing in protective conduit or through adjacent cable/ventilation ducts.
•
Tile plan (picture number 2a and 3a ABS version)
Render and tile to inner edge. Render & tile 6 cm max.
•
Pools with plastic liner (picture number 5 red bronze version, picture number 5a ABS version)
•
Steel, aluminum and polyester pools (picture number 5 red bronze version, picture number 5a ABS version)
•
Pneumatic switch (picture number 6 red bronze version and ABS version)
1a
Concrete
Pneumatic
switch
housing
Shuttering
screws
M 6x35 if required
24
dimensions in cm
Shuttering
24
Sticker „top"
Ø17
Air net tube 8 m long
Instal floor fitting
flush with floor
Protective sleeve for
pneumatic tube Wall
thickness 24 -100 cm
24
approx 5-10 cm
above waterlevel
Wall fitting
for suction
unit
Stopper 2"
2" PVC/ABS tube, elbow
Supplied by pool builder
14
2a
Render & tile
to inner edge
Render & tile
6 cm max.
3a
6 cm