Bosch Professional GO 1 609 92A 3WU Notice Originale page 16

OBJ_BUCH-3206-003.book Page 16 Wednesday, September 20, 2017 2:06 PM
16 | English
Assembly
 Before any work on the machine
(e. g., maintenance, tool change,
etc.) as well as during transport
and storage, set the rotational di-
rection switch to the centre posi-
tion. Unintentional actuation of the
On/Off switch can lead to injuries.
Battery Charging (see figure C)
Note: The battery supplied is partially
charged. To ensure full capacity of the
battery, completely charge the battery
in the battery charger before using your
power tool for the first time.
The lithium-ion battery can be charged
at any time without reducing its service
life. Interrupting the charging proce-
dure does not damage the battery.
The lithium-ion battery is protected
against deep discharging by the
"Electronic Cell Protection (ECP)".
When the battery is empty, the machine
is switched off by means of a protective
circuit: The inserted tool no longer
rotates.
 Once the power tool has automati-
cally shut off, do not continue to
press on the spindle, as this can
damage the battery.
Open the cover 7.
Use a USB cable 9 to connect the power
tool to the charger 10.
The battery charge-control indicator 4
indicates the charging progress. During
the charging procedure, the indicator
flashes green. The battery is fully
charged when the indicator lights up
green continuously.
1 609 92A 3WU | (20.9.17)
Bosch Power Tools