EUROM Harstad Manuel D'utilisation page 24

remove the plug from the socket! Do not use a fireplace that is wet inside but
take it to be repaired. Never immerse the fireplace, cable or plug in water or any
other fluid and never touch the fireplace with wet hands.
The connection voltage and frequency, as given on the
6.
device, must correspond to that of the socket to be used
electrical installation must be protected via an earth leakage circuit breaker (max.
30 mAmp.). Never place the fireplace nearby, under or facing a socket or in the
vicinity of an open fire or heat source.
Extend the electric cable fully before inserting plug into
7.
socket and ensure that it does not come into contact with the
fireplace or get hot
or similar and do not place in areas that are walked on frequently. Ensure that it
cannot be stepped on and that no furniture is placed on top of it. Do not bend the
cable around sharp corners and do not roll up too tightly after use.
The use of an extension cable is not advised as this can lead
8.
to overheating and fire.
make sure that it is not damaged and that it is an approved extension cable with
a minimum diameter of 3 x 1.5 mm². Always fully extend the cable in order to
prevent overheating! To avoid fuses being blown, do not use any other
equipment on the same socket or electrical group as the one used for the
fireplace.
Do not use the fireplace outdoors or in areas that are smaller
9.
than 20 mᶟ.
A fireplace contains hot and/or glowing and sparking
10.
components
and/or gases are stored.
Do not use the fireplace nearby or facing furniture, animals,
11.
curtains, paper, clothing, bedding or other flammable
materials
. Keep at least 1 metre from the fireplace!
Never cover the fireplace
12.
blocked as this may pose a fire risk. Never use the fireplace to dry clothing or
place anything on it. Air around the fireplace must be able to circulate freely.
Never install it too close to walls or large objects and never under a shelf,
cupboard or similar.
Prevent foreign objects entering ventilation or outlet
13.
openings on the fireplace
damage.
Never leave a working fireplace unattended but switch off
14.
and then remove the plug from the socket
from the socket if the fireplace is not in use! Remove plug by pulling on the plug
itself; never pull on the cord!
Always switch the fireplace off, remove plug from socket and
15.
let the fireplace cool down
. Do not place the cable under carpet, cover with mats
If the use of an extension cable is unavoidable,
. Do not, therefore, use where fuels, paint, flammable fluids
24
! Inlet and outlet openings should never be
. This may cause electric shock, fire or
before you:
. Always remove the plug
. The