HyperIce Hypervolt 2 Mode D'emploi page 5

The Hypervolt 2 is a handheld percussion massage device that delivers targeted pulses
of pressure to care for muscles, relieve tension, provide a relaxing massage, accelerate
warmup and recovery, and help maintain flexibility and range of motion.
Operating
Turn your Hypervolt 2 ON by pressing the power/speed setting button for three seconds.
Once your device is powered ON the battery level indicator (LED band) at the base of the
handle will illuminate. Press the power/speed setting button again to select speed one. Your
Hypervolt 2 is now ready for use. Change speeds (1-3) by pressing the power/speed setting
button once per speed. The lights will indicate the current speed.
Changing head attachments
Only change attachments after speed setting is turned to off and head attachment stopped
moving. To change head attachments, pull the existing head attachment straight out to
remove and insert the desired head directly into the opening while pushing firmly. For the Fork
head attachment align the tab on the fork with the groove on the opening and push firmly.
Charging
Fully charge battery for up to four hours before first use. To charge, connect the DC end
of the supplied 18V charger to the charging port on the bottom of the handle and plug the
charger into a wall outlet. The LED light band will pulsate to show battery level and indicate
active charging. The LED light band colors correspond to the charge level ranging from red
(low) to green (fully charged). Full charge is indicated when the LED band remains green
and fully illuminated. Battery may be recharged at any time and at any battery level. It is not
recommended to fully deplete the battery to the red LED level. The average runtime is 2+
hours depending on speed level and pressure applied during use.
Cleaning and storage
Make sure the power is OFF and the battery charger is not attached. Use a damp, clean, cloth
and gently wipe your Hypervolt 2. Store in a clean, cool, dry place, out of direct sunlight, when
not in use.
Connecting to the Hyperice App
To connect your device to the Hyperice App via Bluetooth® make sure that your device is
turned on, Bluetooth® is turned on in your phone, and your device is within close proximity.
Select a routine within the Hyperice App and if prompted tap "Scan for Devices." Select your
device when it pops up on the screen. HyperSmart™ will automatically start your device and
adjust the speed and intensity as you follow along with the routine.
Specifications
1. Speed indicators (3)
2. Power/speed setting button
3. Pressure sensor indicators
4. Bluetooth connection indicator
®
5. Interchangeable head attachments (5)
6. Battery level indicator (LED band)
7. Charging port
5
6
7
1
2
3
4