Tristar WK-3215 Manuel D'utilisation page 8

UK
Operation and maintenance
Remove all packaging of the device.
Check if the voltage of the appliance corresponds to the main voltage of your home.
Rated voltage : AC220-240V 50Hz.
Place the device on a flat stable surface and ensure a minimum of 10 cm. free space around
the device. This device is not suitable for installation in a cabinet or for outside use.
Use
The fact that the pot is completely detachable and rotates a full 360 degrees on the circular
base makes the kettle especially easy to use for both left-handed and right-handed people.
The kettle should be used exclusively for boiling water; never use it with other liquids or
ingredients. For the first use boil a full pot of water to clean the pot and discard this water.
You can open the lid by pressing the button (no. 2).
Always remove the pot from the base (no. 7) when filling it to avoid
water dripping into the base.
Always fill the pot between the minimum and
maximum evel markers (no. 3). If insufficient water
is used, the kettle may switch off, with too much
water it may boil over.
Switch the appliance on by pushing down the
On/Off button (no. 5) in the handle.
The indicator lamp (no. 6) will be illuminated.
Once the water is boiling, the on/off switch
returns automatically to the off position.
If the appliance is accidentally switched
on when no water is in, the boil-dry protection will
automatically switch it off. Adding cool water will
then cool the boil-dry protection mechanism which
enable you to use the kettle as normal.
Note:
 Do not pickup the kettle from its base until it has switched off automatically or you have
switched it off yourself first.
 The steam from the device is very hot, avoid any contact, you may seriously burn yourself.
 Do not fill the pot higher than the MAX level indicator or boiling water may spray out.
 The kettle may only be used with the accompanying base.
 The cord should be completely unrolled and not left rolled around the base.
Cleaning
Remove the plug from the outlet
Allow the unit to cool completely before cleaning.
The outside of the kettle can be wiped down with a damp cloth. Never use metal polish.
The base (no. 7) should always be cleaned without water.
Never immerse the kettle and base in water or other liquid.
Decaling
Use a descaling product which is suitable for household appliances.
Follow the instructions on the packaging. Rinse the pot several times with clean water after
decaling.
8