Installation And Connection; Preparing For Installation - IKEA BALANSERAD Mode D'emploi

ENGLISH
must not exceed 4 Pa (4x 10-5
bars). For this reason ensure
that the room is well ventilated.
In case of doubts, please consult
an autorized service assitance
center or similar qualified
person.
• Do not leave frying pans
unattended when frying, as the
frying oil may catch fire.
• Before touching the light bulbs,
ensure that they are cold.
• Do not use or leave the hood
without the light bulb correctly
fitted, as this may cause electric
shock.
• The hood is not a work surface,
therefore do not place any
objects on top of it or overload
it.
• During all installation and
maintenance operations wear
appropriate working gloves.
• This appliance is not suitable for
outdoor use.
WARNING: when the hob is in
use, accessible parts of the
hood may become hot.

Installation and connection

In the event of problems, contact
the Authorized Service Centre. To
prevent any damage, only remove
the appliance from its packaging
at the time of installation.

Preparing for installation

WARNING: this is a heavy
product; the hood should only
be lifted and installed by two or
more people.
The minimum distance between
the hob and the bottom part of the
hood must not be less than 65 cm
for burning gas or other fuels and
50cm for electric cookers.
Before installation also check the
minimum distances stated in the
manual of the cooker.
If the installation instructions for the
cooker specify a greater distance
between cooker and hood, this
distance must be observed.
Electrical connection
Make sure the power voltage
specified on the appliance rating
plate is the same as the mains
voltage.
This information can be found
on the inside of the hood, under
the grease filter. Power cable
replacement (type H05 VV-F)
must be carried out by a qualified
electrician. Contact an authorized
service centre.
If the hood is fitted with an electric
plug, connect the plug to a socket
complying with current regulations,
located in an accessible place.
6