Table des Matières
Publicité
Maintenance
Maintenance and care
Remove the mains plug before maintenance and care.
Take care when maintaining the cutting equipment to ensure
that the cutters can still be operated by the starter mecha-
nism, even if the motor is not running because the cover
has been unlocked.
Wear protective gloves.
Generally garden shredders require little maintenance.
Faults and how to remedy
Problem
Motor does not start
Motor turns over, but does not start
Motor starts, but becomes blocked on
encountering even slight pressure, and
is switched off via motor safety switch.
Reduced output
Guarantee terms
Please carefully retain the guarantee card completed by
the seller, or the proof of purchase.
The company WOLF-Garten provides a guarantee for 24 months
from the date of purchase. This guarantee is in accordance
with the relevant state of technology and the utilisation purpose
/ area of application. The consumer's statutory rights are not
affected by the following guarantee guidelines.
Pre-conditions for the 24-month guarantee entitlement:
- Deployment of the device solely for private use.
The guarantee is reduced to 12 months in the commercial
sector or leasing business.
- Proper handling and observance of all information given in the
operating manual, which forms part of our guarantee terms.
- Observance of the prescribed maintenance intervals.
- No unauthorised alteration of the design.
- Installation of original WOLF replacement parts / accessories.
To maintain their effi ciency and a long life, observe the fol-
lowing:
•
• Slightly grease polished metal components immediately after
Possible cause
- no mains voltage
- defective connection cable
- enclosure top improperly closed
(safety shut-off is activated)
cutters blocked
-
defective capacitor
-
Extension cable too long, or cross-
section too small. Socket too far away
from main connection, and cross-sec-
tion of connection lead too small
One edge / both edge of the knife
become blunt.
- Presentation of the completed guarantee card and/or proof
of purchase.
This guarantee does not extend to normal wear-and-tear on
blades, blade mounting components or friction disks, V-belts/
toothed belts, running wheels/tyres, air filters, spark plugs
and spark plug connectors. Any guarantee claim shall be
immediately void in the event of unauthorised repairs. Faults
and defects which can be traced to material or manufacturing
faults will be rectified exclusively by our contracted workshops
(the seller has the right to remedy a defect) in your vicinity, or
by the manufacturer if the latter is closer. Any claims going
beyond the provision of a guarantee are ruled out. There is
no entitlement to a replacement. Any transport damage should
be reported not to us but to the shipper in question since,
otherwise, any compensation claims vis-à-vis the shipper
would be voided.
After shredding, the machine must be cleaned inside and outside
use (to prevent rusting)
Elimination
- check fuse
- have it inspected (electrician)
- close and bolt down enclosure top cor
rectly, remove any dirt present
- switch machine off, disconnect mains
plug, and clean interior of machine
- have machine repaired by manufac-
turer or approved company
Extension cable at least 1,5 mm
maximum 25 m long. Cross- section
of at least 2,5 mm
The blades must be changed.
2
,
2
in longer cables.
.
11
11
Publicité
Table des Matières
