Functional Description; Intended Use; Product Features - Bosch GKS 190 Professional Notice Originale

OBJ_BUCH-813-001.book Page 21 Tuesday, September 30, 2008 1:13 PM
Use suitable detectors to determine if utili-
ty lines are hidden in the work area or call
the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
Do not operate the power tool stationary. It
is not designed for operation with a saw ta-
ble.
Do not use high speed steel (HSS) saw
blades. Such saw blades can easily break.
Do not saw ferrous metals. Red hot chips
can ignite the dust extraction.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.

Functional Description

Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
Bosch Power Tools

Intended Use

The machine is intended for lengthways and
crossways cutting of wood with straight cutting
lines as well as mitre cuts in wood while resting
firmly on the workpiece. With suitable saw
blades, thin-walled non-ferrous metals, e. g.,
profiles, can also be sawed.
Working ferrous metals is not permitted.

Product Features

The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 On/Off switch
2 Safety switch for On/Off switching
3 Auxiliary handle
4 Spindle lock button
5 Scale for mitre angle
6 Wing bolt for bevel-angle preselection
7 Wing bolt for parallel guide
8 Cutting mark, 45°
9 Cutting mark, 0°
10 Parallel guide
11 Retracting blade guard
12 Base plate
13 Lever for retracting blade guard
14 Sawdust ejector
15 Blade guard
16 Allen key
17 Clamping bolt with washer
18 Clamping flange
19 Saw blade*
20 Mounting flange
21 Saw spindle
22 Extraction adapter*
23 Clamping lever for cutting-depth preselec-
tion
24 Cutting-depth scale
25 Wing bolt for bevel-angle preselection
26 Set of screw clamps*
27 Guide-rail adapter*
28 Guide rail*
1 619 P06 540 | (30.9.08)
English | 21