HQ Power PROMIX400US Notice D'emploi page 5

CUE: press this button to monitor the channel with headphones. You can select multiple channels
6
at once. Press again to cancel the selection.
Headphones controls
PHONES: plug a headphone into this jack for audio monitoring.
LEVEL: adjust the output level of the headphones
7
MIXING: mixing adjustment knob. Turn to the left to hear channel(s) selected with CUE switches.
Turn to the right to hear master output. At the centre position, the levels for cue and master are
even.
8 Channel fader: set level of the channels with these sliders.
9 Master fader: master volume control
CROSS FADER ASSIGN A/B: select the channels A and B for the cross fader.
10
Note: channels that are not assigned to the cross fader are output without passing through the
cross fader.
Cross fader curve selector: select one of the cross fader start-up curves (abrupt or smooth
11
transition).
Cross fader: moving the slider from left to right will fade in channel B (louder) while fading out
12 channel A (more quiet). In the middle position, both channels are played at equal volume. Use the
cross fader assign buttons [10] to select channels A and B.
13 Display. See further in this manual for more information.
14 SD card slot: insert an SD card into this slot.
15 USB port: insert a USB storage medium to this port.
16 SD/USB button: press once to select SD card audio source; press again to select USB.
FOLDER/TRACK button: press to switch between folder and track searching. If the LED is on,
17
folder mode is enabled. If the LED is off, track mode is enabled.
18
: press once for next track/folder, press and hold to fast forward
19
: press once for previous track/folder, press and hold to fast backward
SINGLE/CONTINUE button: switch between single and continuous play mode. The selected
mode is indicated on the display.
•
20 Single mode: play a selected track and stop playback at the end of the track.
•
Continuous mode: play a selected track and continue with the next track until the end of the
folder.
21 IN button: press to set the starting point for a loop
OUT button: press to set the ending point for a loop. The selected part will now play repeatedly.
22
Press again to exit the loop.
23 RELOOP button: press to jump back to the start point of the loop.
Speed control (PITCH): use this slider to increase or decrease the speed of the track with max.
24
16%. Push up to slow down speed.
25 PITCH button: activate/deactivate pitch fader.
PITCH BEND + (up) button: press and hold this button to instantly increase the pitch. Release
26
to return to original setting.
PITCH BEND – (down) button: press and hold this button to instantly decrease the pitch.
27
Release to return to original setting.
CUE button: during playback, press this button to skip back to a specified cue point.
The cue point is the point where you want the song to start. To specify the cue point in a song:
28
play the track and pause it at the desired cue point. Use the search buttons for fine-tuning. Let the
song play again. When you press CUE, the song is instantly returned to the cue point.
29 BRAKE button: start or stop the track at a slower speed than normal (track slows down).
V. 02 – 09/03/2012
PROMIX400US
5 ©Velleman nv