Table des Matières

Publicité

INTRODUCTION
Congratulations on your purchase of a Velocette 12R.
The Velocette 12R is part of the Trace Elliot Velocette range. It is a no nonsense, compact,
purists valve guitar amplifier and has the minimum controls necessary to produce a good
range of sounds, from clean to overdriven, into its single speaker.
The circuit topology has been based on traditional guitar amplifier designs, with new
ideas incorporated where beneficial.
The main preamp and power stage sections are 100% valve. The valves used are two
ECC83/12AX7's and two EL84/6BQ5's run in Class A.

REAR PANEL CONTROLS

VELOCETTE 12R
HI
LO/LINK
BRIGHT
INPUTS
SWITCHABLE OUTPUT - CLASS A
VALVE GUITAR AMPLIFIER
Inputs - Hi & Lo/Link
Two jack sockets are provided for connection to your instrument.
The HI input is a high impedance, high sensitivity input. This can be used with both
passive and active guitars and, depending on the level of output from the guitar and the
VOLUME setting, allows the amplifier to be driven hard into overdrive, if desired.
The LO/LINK socket can be used in two ways. Firstly as a lower impedance, low
sensitivity input, for use with high output guitars when the user wishes to keep the
overdrive under control. Alternatively this socket can be used as a LINK to chain together
two or more Velocettes, simply plug your guitar into the HI socket, take an output from
the LO/LINK socket and plug this into the input of the next amplifier in the chain.
Bright
The BRIGHT switch adds more high frequencies when selected. It works in the traditional
way, therefore it has more effect at lower VOLUME settings.
VOLUME
TONE
REVERB
MANUFACTURED IN THE UNITED KINGDOM BY:- TRACE ELLIOT LIMITED
EXT SPEAKER
OUTPUT
OUTPUT POWER
PENTODE
15 WATTS RMS
TRIODE
6 WATTS RMS
30 WATTS PEAK
16 Ω
FOOTSWITCH
SERIAL No:-
POWER
TO REDUCE THE RISK OF FIRE OR
PENTODE
ELECTRICAL SHOCK DO NOT EXPOSE
(FULL POWER)
THIS EQUIPMENT TO RAIN OR MOISTURE.
STANDBY
THIS APPARATUS MUST BE EARTHED.
FOR CONTINUED PROTECTION
TRIODE
AGAINST RISK OF FIRE REPLACE ONLY
(LOW POWER)
WITH SAME TYPE AND RATING OF FUSE.
UTILISER UN FUSIBLE DE RECHANGE DE
MEME TYPE ET CALIBRE.
V A.C.
50/60 Hz
MAINS INPUT 100 V . A
(1.0 A @ 115 V)
OFF
ON
100/115 V - T1.0 A
230 V - T500 mA
3

Publicité

Table des Matières
loading

Table des Matières