Rear Panel Controls - TRACE ELLIOT Velocette twin Mode D'emploi

INTRODUCTION
Congratulations on your purchase of a Velocette Twin.
The Velocette Twin is part of the Trace Elliot Velocette range. This is basically a range of
no nonsense, compact, valve guitar amplifiers with the minimum controls necessary to
produce a good range of sounds. However, with the addition of such features as a
switchable gain boost, stereo effects loop, pseudo-stereo reverb, and a stereo power
stage, the 'Twin' model takes the range as far as it could possibly go while still justifying a
'Velocette' badge.
The circuit topology has been based on traditional guitar amplifier designs, with new
ideas incorporated where beneficial.
The main preamp and both power stage sections are 100% valve. The valves used are
four ECC83/12AX7's and four EL84/6BQ5's run in Class A in stereo (two EL84's per side).

REAR PANEL CONTROLS

VELOCETTE
VOLUME
TWIN
PULL GAIN
HI LO/LINK BRIGHT
INPUTS
Inputs - Hi & Lo/Link
Two jack sockets are provided for connection to your instrument.
The HI input is a high impedance, high sensitivity input. This can be used with both
passive and active guitars and, depending on the level of output from the guitar and the
VOLUME setting, allows the amplifier to be driven hard into overdrive, if desired.
The LO/LINK socket can be used in two ways. Firstly as a lower impedance, low
sensitivity input, for use with high output guitars when the user wishes to keep the
overdrive under control. Alternatively this socket can be used as a LINK to chain together
two or more Velocettes, simply plug your guitar into the HI socket, take an output from
the LO/LINK socket and plug this into the HI input of the next amplifier in the chain.
Bright
The BRIGHT switch adds more high frequencies when selected. It works in the traditional
way, therefore it has more effect at lower VOLUME settings.
TONE REVERB FOOTSWITCHES
GAIN EFFECTS
REVERB
15W + 15W STEREO CLASS A VALVE GUITAR AMPLIFIER
EFFECTS LOOP EXTERNAL SPEAKER OUTPUTS
SERIES
OUTPUT POWER
PER CHANNEL
PARALLEL
15 WATTS RMS
SEND SEND RETURN RETURN 30 WATTS PEAK LEFT
LEFT/MONO RIGHT
SERIAL No:-
TO REDUCE THE RISK OF FIRE OR
Ω
8 ELECTRICAL SHOCK DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
THIS APPARATUS MUST BE EARTHED.
Ω FOR CONTINUED PROTECTION
16 RIGHT
AGAINST RISK OF FIRE REPLACE ONLY
WITH SAME TYPE AND RATING OF FUSE.
UTILISER UN FUSIBLE DE RECHANGE DE
MEME TYPE ET CALIBRE.
MANUFACTURED IN THE UNITED KINGDOM BY:- TRACE ELLIOT LIMITED
MAINS INPUT 200 V . A
POWER
(2.0 A @ 115 V)
OFF
STANDBY
ON
100/115 V - T2.0 A
V A.C.
50/60 Hz 230 V - T1.0 A
3