Attaching The Shoulder Strap - Makita BBX7600CA Instructions D'emploi

ATTACHING THE SHOULDER STRAP

Attachment Procedure
Attaching the shoulder strap to the blower.
• Loop the end of the strap through the lower part of the hanger as
shown in the figure at right. The side of the strap that has the folded tip
should be facing outwards. Then, bring the end of the strap back over
the hanger and thread the remaining length of the strap through the
buckle (1). Tighten the buckle (1) by pushing it towards the hanger in
the direction of the arrow shown in the drawing while pulling on the
strap in the opposite direction.
• After attaching the strap, tighten the buckle to the hanger. Tug strongly
at the strap to make sure that the strap is secure and will not come
undone.
• Attach the hook at the bottom of the shoulder strap to the ring on the
frame.
• Make sure that the strap is not twisted.
Caution: Please make sure that the strap is attached with the folded tip
facing outwards. If the strap is used with the outside of the strap
facing in, there is the risk that the strap may come loose caus-
ing the operator to drop the blower.
(1)
Quick-disconnect
spring hook
9