Electrical Connection - Faber GALILEO SMART Manuel D'utilisation

detergents to be used. The use of protective
detergents is recommended.
•
boiled over, using a scraper pad suitable for
vitreous ceramic, while the cooker hob is still
hot. Follow the manufacturer's recommendations
regarding scraper pads to be used.
•
that has spilled during cooking, using a scraper
pad suitable for vitreous ceramic, while the
cooker hob is still hot. If you do not, the residue
may damage the vitreous ceramic surface.
• Remove any melted plastic using a scraper pad
suitable for vitreous ceramic, while the cooker
hob is still hot. If you do not, the residue may
damage the vitreous ceramic surface.
• Remove limescale using a small amount of
or lemon juice, once the cooker hob has cooled
down. Then clean again with a damp cloth.
4. REQUIREMENTS FOR
KITCHEN UNITS
•
with the kitchen worktop, on a kitchen unit with
a width of 600 mm or more.
•
materials, the guidelines and regulations relating
must be followed strictly.
•
materials and veneered wood) must be mounted
with heat-resistant adhesives (min. 100 °C): the
use of unsuitable material and adhesives may
result in warping and detachment.
•
allow for electrical connection of the device.
Wall-mounted units above the device must be
space required to work in comfort.
• The use of decorative hardwood borders around
the worktop behind the device is allowed,
provided the minimum distance always complies
with the indications provided in the installation
drawings.
•
and the rear wall is indicated in the installation
the side wall, 40 mm for the rear wall and 500
mm for any wall-mounted units above it).
•
adhesive seal supplied along the whole outer
edge of the cooker hob prior to installation.
5. ELECTRICAL
CONNECTION
• Electrical connections must be carried out by a
trained technician.
• This appliance has a "Y" type connection, so
the power cable must have a "neutral" wire. The
power cable must be at least of type H05VV-F.
SINGLE PHASE, TWO PHASE and THREE
PHASE connection: min. cross-section of wires:
• The connection terminals can be accessed by
• Check that the domestic power supply
current) are compatible with those of the
appliance.
• Connect the appliance as shown in the diagram
(in compliance with reference standards in force
nationally for mains voltage).
• It is recommended that you use the H05V2V2-F
cable, follow the instructions provided here: for
three phase connection, separate the 2 wires
and remove the blue sheathing from the grey
wires.
6. DISPOSAL
• The symbol on the product or on the packing
material indicates that the product must not be
treated as domestic waste; on the contrary it
must be sent to a collection point that recycles
electrical and electronic appliances. Disposing
of the product properly will help avoid potentially
human health. For further information on how
to treat, recover and recycle this product, please
domestic waste disposal service or the shop
from which you purchased the product.
• The appliance complies with directive 2012/19/
EU relating to reduction in the use of dangerous
substances in electrical and electronic appliances
and waste disposal.
7