NEW POL XF5 500 Mode D'emploi page 18

GB
The machine must be installed by professionally qualified technicians, according to the manufacturer's
indications. Incorrect installation may result in damage to persons and property.
The machine can be installed anywhere, provided the temperature in the place of installation is not below
3°C and the cables and hoses at the rear of the machine are not crushed in any way.
For transport purposes the swinging unit in the machine is blocked
using 4 spacers with screws. Before starting the machine these
spacers and lock screws must be removed, and stored for use in
the event of a possible change of location.
Block off the holes with the plugs provided, which can be found
in the bag containing the documents.
N.B. If the spacers fall into the inside of the machine, open
the rear panel, recover them and then replace the panel.
For transport purposes the swinging unit in the machine is blocked
using 4 spacers with screws. Before starting the machine these
screws must be removed using a screwdriver.
Insert a screwdriver in the holes and proceed as shown in the
figure to recover the 4 plastic spacers.
N.B. If the spacers fall into the inside of the machine, open
the rear panel, recover them and then replace the panel.
18
INSTALLING THE MACHINE
(ACCORDING TO MODEL)
2
3
2A
3A
SM1511