Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
REVOLUTION
EN
Place tank support on the most suitable
21
lower part of the rear area of the cab.
Mark and drill Ø 9 on the cab bearing in
mind the vertical position of the support.
Minimum (6) fastening drill holes.
Place M6 rivet nuts and fix the support
22
with M6/100x30 screws.
(*) – Where it does not lean on the even
part, place a 10mm separator and screw
M6/100 x 40.
Fasten the tank pump unit with (2) sheet
23
metal screws 5.4x19 mm.
Rivet nut
36
Allen screw 6/100x30
Grower washer Ø 6
Flat washer Ø 6
Supports
Tank
Grower washer Ø 6
Flat washer Ø 8
Support
Rear part cab
10 mm separator
Rear part cab
®
Publicité
Table des Matières
