dirna Bergstrom bycool blue line REVOLUTION 12 V Instructions De Montage page 31

REVOLUTION
Fasten the fastening supports by tightening the
17
nut until the outer EPDM seal tightening of the
equipment is between 3 and 6mm.
Important: To avoid possible water leaks into
the inside of the cab the EPDM seal tightening
must be adjusted with the base of the Bycool as
indicated in the drawing.
3-6mm.
Cab roof
Tighten the nuts until the
seal tightening of the rubber
17
is between 3 and 6 mm.
Screw (4) M8 nuts to the support and (4) to
18
the base of the Bycool.
EPDM seal
10 mm*
(*) (approx. after tightening)
Base
Support
31
Check compression
thickness using a tape
measure in the four
corners.
EPDM seal
EN
®
17
18