Water Connection; Electrical Connection - Inventum IVW6008A Manuel D'utilisation

WATER CONNECTION

• Make sure that the indoor plumbing is suitable for installing the
appliance.
• Install a filter at the water supply to avoid damage to the
appliance due to contamination from the water (sand, clay, rust,
etc.).
• Use the new water inlet hose supplied with the appliance.
Before making the connection, run water through the hose.
• Make sure that you connect the water inlet hose directly to the
water tap. The pressure of the water tap must be a minimum of
0,03 MPa and a maximum of 1 MPa. Install a pressure relief
valve if the pressure is more than 1 MPa.
• After connecting the appliance, open the water tap completely
and do a check for leaks.
• The appliance is supplied with a double-walled aquastop. The
system automatically cuts off the water supply if the water inlet
hose is leaking and the space between the walls is filled with
water. Do not cut into the aquastop and make sure that the
aquastop does not get twisted or stuck.
• Do not use a drain hose that is longer than 4 meter. As a result,
dishes can remain dirty. The manufacturer will not accept
responsibility.
• The appliance must be connected to the water mains using the
newly supplied hose sets. Do not reuse old hose sets.

ELECTRICAL CONNECTION

• Make sure that the mains plug of the appliance is connected to a
grounded mains socket. The manufacturer is not responsible for
damage resulting from using the appliance with a mains socket
that is not grounded.
• Make sure that the voltage and the frequency values for the
current correspond to the values of the rating plate.
English • 33