Parameter Settings - HoMedics HTD8816C TE-350-EU Mode D'emploi

Mode conversion
• When the device is running, pressing the MODE button to cycle conversion between
"body" mode and "surface" mode.
• "Body" mode is used for measuring human body temperature, the "surface " mode is
used to measure the surface temperature. (The factory default is "body" mode)
Recalling and Erasing Memory Data
The last temperature taken before the thermometer powers off is stored in memory, up
to 50.
1. In the boot or shutdown state, short press the MEMO button to view the history of
measured values.
2. An empty memory cell shows "---°C" or "---°F".
3. Temperature readings can be stored in memory. Up to 50 temperature readings can
be stored into the memory cells and automatically overwrite historical data.
4. In boot mode, press the MEMO button until the LCD display "CLR", which means that
all stored data is cleared completely.

Parameter settings

As below step:
1. Unit Set-F1
Under the boot mode, long press the "MODE" button to enter F1, press the "MODE"
or "MEMO"button to switch Celsius and Fahrenheit temperature units, press the On/
Scan button to confirm the unit settings (factory default is Celsius).
2. Fever alert set-F2
Under F1 state, press ON/scan button to enter the F2, press the "MEMO" button to
decrease 0.1°C, press the "MODE" button plus 0.1°C, long press to accelerate the
speed of temperature regulation, and finally press the ON/scan button to save. (The
factory default is 38.1°C)
3. Prompt sound settings-F3
Under F2 state, short press ON/scan button to enter F3, press MODE button or
MEMO button to set voice switch, and press the ON/scan button to confirm the
settings. (The factory default is the voice Prompt to open).
GB | 12