Rack Accessories
Flip Tines
The racks consist of tines that can be folded down depending on what you
may need to load in the rack. To fold down, grasp the folding tine and release
from notch. Push folding tine downward to desired position as shown in Fig-
ure 6.
Extra Tall Item Sprinkler
If an item is too tall to be placed in the bottom rack even with the upper
rack in the raised position, remove the empty upper rack by pulling it out of
the dishwasher until it stops. Pull the front of the rack upward and out-
ward until the rollers are completely free of the roller guides.
Set the upper rack aside. Push the roller guides back into the dishwasher.
Insert the Extra Tall Item Sprinkler into the upper rack spray outlet and
turn the sprinkler clockwise to lock into position. See Figure 7.
Note: Keep the vent on the tub's left side clear by placing tall items such as plas-
tic cutting boards and tall baking sheets on the bottom rack's right side or cen-
ter.
To avoid dishwasher damage, do not reinstall the upper rack without remov-
ing the Extra Tall Item Sprinkler.
Plastic Item Clips
Light-weight plastic accessories (cups, lids, etc.) can be held securely by the
plastic item clips. See Figure 8.
RackMatic®
The height of the upper rack can be adjusted in 3 steps to create more space.
Pull the upper rack out of the dishwasher until it stops.
1
To lower the rack, push the lever inward then upward.
2
3
To raise the rack, hold the basket on the sides of the upper rack and lift
up.
Note: Before pushing the upper rack into the dishwasher, ensure the rack height
is the same on both sides. If the height is not the same on both sides, the dish-
washer door will not shut and the upper rack spray arm will not connect to the water inlet.
NOTICE
Figure 6
Figure 7
Figure 8
Figure 9
9