LaserLiner BeamControl-Master Mode D'emploi page 16

Working with the SensoCommander (optional)
The SensoCommander can recognise the laser beam
over long distances. Move the SensoCommander up
and down through the laser beam until the middle
display appears. Now mark the height on the all-round
marking groove. The Spotlite additionally shows the
measured height.
Universal mount (optional):
The receiver can be installed on levelling staffs with the aid
of the universal mount. To do this, insert the universal mount
into the laser receiver and secure on the levelling staff with
the aid of the screw. To release the universal mount from the
laser receiver, turn the quick release lock in the direction of
the arrow.
Adjust horizontal
Start adjusting the vial (X) by turning
the levelling screws (A) and (B).
!
Please look always vertically at the vial
in order to avoid reading errors.
Now turn the levelling screw (C) to adjust
the vial (Y).
!
Repeat the whole action, if necessary.
Adjust vertical
Set the BCM up vertically on its integral
handles or mount the BCM onto a stand.
Now adjust only the vial (Z) with the
levelling screw (C).
16
EN
A
vial X
vial Z
2 1
B
vial Y
C
C