Changing The Type Of Time Display; Delayed Start; Changing The Preset Time; Aborting A Time-Delay - Brandt WFH 1270 K Guide D'installation Et D'utilisation

2. Press the »Clock«
play flashes.
3. Turn the »Delayed start«
until the current time is shown. The
display stops flashing.
3 When a programme is selected or run-
ning, the display shows the time the
programme cycle will be completed.

Changing the type of time display

The time of a programme is displayed on
two various ways:
– Showing the current time of the end
of a programme cycle, e.g.
"20.30".
This type of display is preset at the fac-
tory. All pictured examples are relative
to this type of display.
– Showing the programme duration
resp. remaining time of a programme
cycle, e.g.
"1.30".
If you want to change the type of display:
• Press the two marked additional keys
at the same time and wait approx.
2 seconds.
The new type of display shows, e.g.:
– "20.30" (End of cycle time) or
– "1.30" (Remaining time, pro-
gramme duration).
button. The dis-
button,

Delayed start

With this function you can delay the pro-
gramme start individually.
A
Do not use liquid detergent with it!
Risk of stains.
3 You set the time the programme
should be completed; the appliance
calculates the start time.
Important: The clock must be set to
the correct time of day (see above).
Here's how to proceed:
1. Open tap, load drum, fill in detergent.
2. Select programme, select additional
functions and spin speed if necessary.
3. Turn the »Delayed start«
until the desired time for the pro-
gramme end shows.
• Don't press the »Start/Pause«
ton. The programme starts automati-
cally. The programme sequence indica-
tor »Delayed start«
3 During the time-delay period more
laundry can be loaded.

Changing the preset time

The preset time setting can be changed
even after the time-delay period has started:
• Turn the »Delayed start«
until the desired time for the pro-
gramme end shows.

Aborting a time-delay

An active time-delay function can be
aborted at any time:
1. Set the programme selector to »Stop«,
then wait approx. 2 seconds.
2. Set the programme selector back to
the desired programme.
3. Press the »Start/Pause«
start the programme.
button
but-
indicates that.
button
button to
G
53