Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Child-proof lock
With the child-proof lock the appliance
can be made child-safe.
Activating the child-proof lock:
• Press both indicated buttons simulta-
neously and hold them for approx.
2 seconds, until the »child-proof lock«
indicator lamp goes on.
3
Then a running programme can not
be changed anymore, and the door
can not be opened.
3
If the programme selector is set to
»Stop«, the programme stops. To con-
tinue with the programme, set the
programme selector to the initial pro-
gramme.
Deactivating the child-proof lock:
• Press both indicated buttons simulta-
neously and hold them for approx.
2 seconds, until the »child-proof lock«
indicator lamp goes out.
Spin speed selector
3
Each programme automatically sets
the maximum reasonable spin speed
(see "Programme Table").
The currently set value is indicated
(range depending on model).
G
52
1600
1200
900
600
For especially sensitive textiles the spin
speed should be reduced.
• By pressing the »Spin speed«
ton repeatedly you can reduce the
spin speed – or completely disable the
spin.
• If set to »No spin«
done; only the water is pumped off.
3
The higher the spin speed, the lower
the residual moisture.
If you wish to dry your laundry in a
dryer afterwards, select the maximum
spin speed – this helps saving energy
when drying.
Display
Depending on the operating mode the
display shows
– the current time,
– the time of the programme end.
3
If no programme is selected, the dis-
play will turn off after approx.
1 minute (to save energy).
When you actuate the programme se-
lector or the »Start/Pause«
»Clock«
button, the display turns
on again.
Setting the time of day
The time needs to be set:
– after the appliance has been connect-
ed to the mains,
– after a power failure,
– at change-over of summer/winter time.
3
If the clock is not set, the display
shows "00.00".
Here's how to set:
1. Set programme selector to »Stop«.
but-
no spinning is
or
Publicité
Chapitres
Table des Matières
