Warning Signals; Service And Maintenance; Environment - Festool TPC 18/4 Notice D'utilisation D'origine

English
10.1 Kickback stop
WARNING
Risk of injury
The kickback stop does not guarantee com­
plete protection against a kickback.
► Always concentrate on your work and refer
to the safety instructions and warnings.
The kickback stop is triggered if the tool
is jammed, causing the power tool to
rotate around the screw axis suddenly
and unexpectedly. The power tool switches off,
beeps once and the LED light flashes continu­
ously.

11 Warning signals

Warning signals occur and the power tool switches off in the following operating states:
Signal
Beeps once.
Beeps once.
Beeps twice.
Beeps continuously. -

12 Service and maintenance

WARNING
Risk of injury, electric shock
► Always remove the battery pack from the
power tool before performing any mainte­
nance or service work.
► All maintenance and repair work which re­
quires the motor housing to be opened
should always be carried out by an author­
ised service workshop.
Customer service and repairs must
only be carried out by the manufac­
turer or service workshops. Find the
nearest address at:
www.festool.co.uk/service
20
LED light
-
Flashes continuously. Kickback stop triggered.
-
After the kickback stop has been triggered:
► Release the on/off switch [1-5].
► Eliminate the cause of the jam.
► Press the on/off switch again.
10.2 Bit store [1-14]
Risk of injury from metal cuttings in the bit
store.
► Clean the bit store regularly and clear out
metal cuttings.
Magnetic, for storing bits and bit holders.
Cause
Battery pack empty/incom­
patible.
Power tool overloaded.
When pressing the on/off
switch: Power tool has over­
heated.
Preset torque reached.
The power tool is faulty.
Always use original Festool spare
EKAT
4
parts. Order no. at:
www.festool.co.uk/service
5
3
2
1
To ensure constant air circulation, always keep
the cooling air openings in the motor housing
clean and free of blockages.
Keep the contacts on the power tool, charger
and battery pack clean.

13 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
CAUTION
Action
Charge/change the battery
pack.
Reduce the load on the pow­
er tool.
Once it has cooled down, re­
start the power tool.
See section 10.1.
-
Contact the manufacturer to
rectify the fault.