Kermi 12 Vplus Instructions De Montage page 5

Push pre-installed stand bracket onto bra-
cket base and adjust the ground clearance
(Fig. 8).
Refer to table in Fig. 9 for dimensions for in-
stalling the stand brackets on the radiator.
Note
Second stand bracket on the inside, divi-
ded ZB01480001 (SK) and from BL ≥1800,
pre-install centre brackets ZB01470001
(MK) according to respective installation
instructions.
2.3 Installation of stand bracket type
12 Vplus with radiator
Attach the pre-installed stand bracket type
12 Vplus at the valve end of the radiator
(Fig. 10–13).
The stand bracket is clamped to the radiator
by tightening the hexagonal nut (Fig. 13).
Install the second stand bracket according
to installation instructions at the other end
of the radiator, install the centre bracket in
the middle.
Place the radiator on the bracket bases and
position it at the installation location, mark
off drill holes (Fig. 14).
Remove the radiator and drill the holes
(Fig. 15).
Position the radiator, align it, and secure it
using suitable dowels and screws (4 screws
per bracket, max. Ø10 mm) (Fig. 16).
Align the radiator horizontally: Loosen the
grub screw (9) and the hexagonal nut (8)
on each bracket and correct the clearance,
then tighten again (Fig. 17).
Cover the radiator completely again with
the packaging until the radiator is commis-
sioned (Fig. 18).
2.4 Installation of the stand bracket
foot bases with subsequent installa-
tion of the radiator
The assembly jig ZK01370001 (from
BL≥1800 also the ZK01380001), which
is available as an accessory, can be used
for pre-assembly of the FTP, PTP, and PLP
type 2.
Position bracket bases (10) (number and
spacing in Fig. 9), mark up drill holes
(Fig. 19).
Remove bracket bases and drill the holes
(Fig. 15).
Position the bracket bases, align them, and
secure using suitable dowels and screws (4
screws per bracket, max. Ø10 mm) (Fig. 20).
Attach the pre-installed stand bracket type
12 Vplus at the valve end of the radiator,
the stand bracket on the inside, divided at
the other end of the radiator, centre bracket
in the middle (Fig. 10–13).
The stand bracket is clamped to the radiator
by tightening the hexagonal nut (Fig. 13).
Place radiator with brackets on attached
bracket bases (Fig. 21).
Align the radiator horizontally: Loosen the
grub screw (9) and the hexagonal nut (8)
on each bracket and correct the clearance,
then tighten again (Fig. 22).
Cover the radiator completely again with
the packaging until the radiator is commis-
sioned (Fig. 18).
EN – Installation
5