BH FITNESS G2362 Instructions De Montage Et Utilisation page 14

1. ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit.
(97) Main body.
(24) Main post.
(106) Handlebar tube.
(95) Front stabiliser bar with wheels.
(67) Rear stabiliser
adjustable feet.
(51L) Left footrest.
(51R) Right footrest.
(48L) Pedal left foot.
(48R) Pedal right foot.
(16L) Top focus bar, left.
(16R) Top focus bar, right.
(1) Monitor.
(21L) Bottom trim covers, left and
right. (L) for the knuckle joints on the
focus bars.
(21R) Bottom trim covers, left and right
(R) for the knuckle joints on the focus
bars.
(52) Bottom cover, left foot.
(52) Bottom cover, right foot.
(102) Bottom post cover.
(8L) Post cover L.
(8R) Post cover R.
(113) Transformer.
2. FITTING THE STABILISER
BARS.-
Bring the front stabiliser bar with wheels
(95) to the main body (97) positioning
the wheels at the front of the unit, Fig.1,
insert screws (52) and tighten securely.
Take the rear stabiliser bar with
adjustable feet (67), Fig.1, insert the
bolts (35) and tighten securely.
3. FITTING THE BOTTOM
POST COVER.-
Take the main post (102) and insert
the bottom post cover (24) in the
direction of the arrow, Fig.2.
4. FITTING THE MAIN POST.-
Once the bottom post cover, is fitted,
remove the screws (100) and washers
(98) and (99) from the bottom of the
bar with
main post (24).
Bring the main post (24) up to boss on
the main body (97), Fig.2.
Plug connector (2), coming out of the
main post (24), into connector (101),
coming out of the boss on the main
body (97), Fig.2.
Slip the main post (24) over the boss
(97) on the main body in the direction
of the arrow, Fig.2, making sure not to
snag any of the cables.
Lower the bottom trim section (102)
for the main post (24) down over the
boss section of the main body (97),
Fig.2.
5. FITTING THE FOCUS BARS.-
Insert the focus bar spindle (104)
through the spacer bushes on the
main post (24), Fig.3, leaving it
centred.
Fit the spacer washers (17) as shown
in Fig.3. Insert the left focus bar (16L)
(marked with the letter "L") onto the
focus bar spindle (104), Fig.3, then fit
the right focus bar (16R) (marked with
the letter "R") on the other end of the
spindle. Fit the washered bolts (14)
and the flat washers (12-13) and with
the help of the box spanners tighten
securely.
14