General­device­functions; Resets; Ow Playing Information; Nputting Characters - Grundig CMS 5000 BT DAB+ WEB Mode D'emploi

GENERAL­DEVICE­FUNCTIONS
Press »MENU/INFO« to open the menu. Press
again to close the menu and return to playing
screen.
On the menu, rotate the navigate knob or press
» « / » « on the remote control to move along
the entries.
Press »OK/SCAN« to confirm; press »ALARM/
BACK« or » « on the remote control to step
back.
Press and hold » /­MODE« on the device or
press » « on the remote control to switch to
standby mode. The time, date and any active
alarm times display on the screen.
Press » « to wake up from standby.
When album cover is displayed on the play-
ing screen, press »OK/SCAN« to view the full
screen size of the picture.
Presets­
Number of presets: lnternet Radio: 20 l Podcasts:
20 l Spotify: 10 l DAB+: 40 l FM: 40
To store preset, press and hold
BTPAIR« or » « until the display shows the
Save preset screen. Select one of the presets to
save the currently playing station. Store 1-10 pre-
set stations by directly pressing and hold numbers
»1...10/0­ « on the remote control. To play a
preset, press »PRESET/BTPAIR« or » « , then
select one of the listed preset stations. When a
preset station is playing, it shows n ( 1, 2 etc) at
the bottom of the screen. Recall 1-10 preset sta-
tions by directly pressing the number keys on the
remote control.
28­ ­ ENGLISH
Now­playing­information
While stream/DAB/FM is playing, the screen
shows some information about the station, press
»MENU/INFO« or »INFO« to view.
lnputting Character
As each character is selected, the key is built up
near the top of the display.
There are three options accessible by tuning the
navigate reel back before the first characters
» -­« Backspace, »OK« and Cancel.
Press »INFO« to move to the Backspace box as
a short cut.
When­the­device­is­overloaded
The device may process large amount of data
after a period of operation, no matter in which
mode, it will cause the system freeze or malfunc-
tion. Reboot the device if necessary.
First-time­Setup
When powering the device on for the first time,
it asks to setup the OSD language. Choose your
»PRESET/
language and confirm. It displays information
of privacy policy then. Press »OK/SCAN« to
continue. The Wizard installation assistant then
appears, which guides you through the installa-
tion step by step. Select »YES« and confirm your
selection and launch the setup wizard.
If you select »NO«, the next window will ask
you choose if you want to start the setup wizard
again next time you power the device on.
­ - ---------------------------------------------------------