Changing The Housecode - Marmitek MT20 Mini Timer Guide Utilisateur

To suspend the program for channel 1 turn the Buzzer switch to OFF, AND place
the Mode switch in the "Clock Set" position. The On program for BOTH the Alarm
buzzer AND the bedside lamp will then be suspended.
You can control Modules instantly with the Mode switch in the "Clock Set" position,
just as you can when it's in the RUN position, but remember to place the Mode switch
back to RUN and put the Buzzer switch back to the ON position on Sunday night to
resume the wake-up program for weekdays.
Note: Pressing the ON button for Module number 1 with the Mode switch in the RUN
position or Clock Set position does not activate the internal buzzer. This buzzer only
sounds at the times you set.

CHANGING THE HOUSECODE

When you first plug in the Mini Timer it controls X-10 Modules set to Housecode A.. If
you want to change the Housecode:
2. Press the up or down "Time" rocker to select the desired Housecode (as
shown in the display).
3. Set the Mode switch back to RUN.
MT20™
1. Set the Mode switch to "Housecode Set."
17