How To Program A Timed Event; Special Programming Buttons - Marmitek MT20 Mini Timer Guide Utilisateur

7. All Lights On Button. Instantly turns on ALL Lamp/dimmer Modules.

How to program a timed event

1. Place the mode switch in "Prog Set/Review" position.
2. Advance to the desired time.
3. Set the 1-4/5-8 switch to the desired position.
4. Press any of the 4 ON or OFF buttons to set an On or Off time for that Module. This
will program the Mini Timer to turn that Module on (or off) at that time every day.
5. Advance to another time, and press another ON or OFF button as desired.
6. Set the Mode switch back to RUN.

Special programming buttons

1. Mode button. If within 4 seconds after setting an On or Off time, you press the
"Mode" button once or twice until Once shows in the display, you will
modify the program to carry out your programmed event only Once and it
will not repeat on the next day.
Press again (within 4 seconds after setting an On or Off time) until Security is
shown in the display, to modify the program so that your lights (or appliances) will go
on or off at a slightly different time every day (within the programmed hour). With
each press the display shows whether you've selected Once, or Security. If neither
Once nor Security is displayed, the event happens at the same time ev
2. Clear Button. Pressing this (in the Prog/Review Mode) cancels the On time or Off
time being displayed.
3. Wakeup Switch. In the "ON" position an internal wake up buzzer will sound at
the time programmed for Module number 1. When this sounds you can turn
it off by pressing any button to obtain the "snooze" feature. This will turn
the buzzer back on in 10 minutes and will do so each time you operate
snooze.
The alarm can be cancelled by moving the Buzzer switch to "OFF" and back
to "ON" (for wake up the next mo
4. Selector Switch. Used to select whether you want your Mini Timer to instantly
control Modules set to Unit Codes 1 thru 4 or 5 thru 8. You can move the
selector switch back and forth to achieve instant control of 8 X-10 Modules.
You can also move the switch during programming to select which modules
(1-4 or 5-8) you are setting times for.
MT20™
rning).
ery day.
11