If The Display Shows Full; Selector Switch; Instantly Controlling Modules - Marmitek MT20 Mini Timer Guide Utilisateur

If (while in Prog/Review Mode) one of the 4 module ON (or OFF) buttons is pressed
without modifying the current time, and events do exist, each press of the module
ON (or OFF) button cycles through (and displays) all the ON (or OFF) events for that
particular module. I.E. you are "Reviewing" the times that are set. The display also
shows whether the event is a Once event or a Security event. Note if it's a Security
event the actual time that the next event will occur will be shown. If neither Once nor
Security is displayed, the event is a Daily event.
If (while in Prog/Review Mode) one of the 4 module ON (or OFF) buttons is pressed
after modifying the current time, then the time is stored as a new event for that
module. I.E. you can program new events while reviewing the current programmed
events.
While displaying any time for any module it can be deleted using the Clear key. All
events for a module can be cleared by pressing Clear multiple times until the display
shows 0:00.
If an event time is modified and you do not want to store it to any module ON/OFF
button, press Clear. The previous event is now displayed and can be deleted if desired
by pressing Clear again.
If the Mode switch is moved after a time has been changed and without a module
ON/OFF button being pressed, this time is discarded and is not stored in memory.

If the display shows FULL

If FULL is displayed when you try to enter a programmed time, this means that you
have tried to enter an additional time when you have already used up all the available
memory. Cancel one or more of your set times by pressing a number ON (or OFF)
button, then press Clear to clear that event. Then enter another timer event.

Selector switch

1-4 position - With the "Selector" switch in the 1-4 position the 4 ON and
OFF buttons control (and set times for) Modules set to Unit Codes 1 thru 4
respectively.
5-8 position - With the "Selector" switch in the 5-8 position the 4 ON and
OFF buttons control (and set times for) Modules set to Unit Codes 5 thru 8
respectively.

Instantly Controlling Modules

With the Mode switch in the RUN position you can slide the Selector Switch back and
forth to instantly control Modules set to 1 thru 4, or 5 thru 8. Also, in the Prog
Set/Review mode you can set events for modules 1 thru 4, then move the selector
switch and program more events for modules 5 thru 8. See note at Setting something
to happen every day at the same time for maximum number of events you can
program..
MT20™ 15