Setting Up The Mini Timer; Setting The Clock; Controlling X-10 Modules - Marmitek MT20 Mini Timer Guide Utilisateur

SETTING UP THE MINI TIMER

Setting the clock

Plug the Mini Timer into any convenient AC outlet. Fit two AA alkaline batteries in the
battery compartment to protect the time and program for up to 48 hours in the event
of a power outage. If the battery is low, dead, or not installed, the low battery
indicator will show in the display.
When you first plug in the Mini Timer the display will flash. It will also flash if you have
had a power outage and have not installed two AA alkaline batteries or if the
batteries are dead.
2. Press the top of the "Time" rocker to advance to the correct time. A
quick press on the rocker will advance the time by 1 minute. If you hold the
rocker down the display will advance to the correct time faster. If you
overshoot, you can use the bottom rocker to go back.

Controlling x-10 modules

Follow the steps below to make sure you can control your Modules before you
program the Mini Timer.
1. Install and set up all of your Marmitek X-10 Modules referring to the instructions
included with them. Be sure to turn off the power at the main circuit breaker
panel when installing Wall Switch Modules or Micromodules.
2. Set all of your Modules to the same Housecode as the Mini Timer (default is A).
3. Set each Module to a Unit Code Between 1 and 8.
4. Set the Mode Switch on the Mini Timer to the "RUN" position.
5. To turn On a particular Module, set the selector switch to 1-4 or 5-8, then press the
ON button corresponding to the number you set on the Module you want to control.
Then press and hold Bright or Dim to brighten or dim the light (Lamp/dimmer
Modules only).
6. To turn Off a particular Module, set the selector switch to 1-4 or 5-8, then press
the OFF button corresponding to the number you set on the Module you want to
control. The display shows On or Off next to the module number for the button you
pressed.
To turn on ALL lights connected to Lamp Modules and Wall Switch Modules (with
the same Housecode as the Mini Timer), press the "All Lights On" button. This does
not affect appliances.
12
1. Set the mode switch to "Clock Set."
© MARMITEK