Setting A Timed Event To Occur Once Only; Setting A Timed Event To Occur In The "Security" Mode; Reviewing Timer Events - Marmitek MT20 Mini Timer Guide Utilisateur

If you try to set an on or off time and the memory is full, the display will read FULL. To
clear this, press the Clear button.

Setting a timed event to occur Once only

If (within 4 seconds after setting an On or Off time) you press the "Mode" button
once or twice until Once shows in the display, you will modify the program for that
particular Unit Code to occur only Once.
The event you have programmed will happen (at the time you have programmed)
within the next 24 hours, and will then be automatically cleared from memory and
will not happen again the next day.
You can mix Once and Daily events for the same Unit Code (up to the 64 maximum
events for all 8 unit codes).

Setting a timed event to occur in the "Security" mode

If you advance to a specific time, and then press one of the ON or OFF buttons, you
will set an On or Off time for that Unit Code to occur every day at exactly the same
time.
If however, within 4 seconds after setting an On or Off time, you press the "Mode"
button once or twice until Security is shown in the display, you will modify the
program for that particular Unit Code to occur every day at a slightly different time
each day.
The event you have programmed will happen at the time you have programmed on
the first day, and will then happen at a different time on each subsequent day (within
the hour you have programmed). For example:
If you advance to 7:35 PM, press the ON button for number 2 and then (within 4
seconds) press the Mode button once or twice until Security shows in the display, the
Module(s) set to Unit Code number 2 will go On at exactly 7:35 PM on the first day
and any time between 7:00 PM and 8:00 PM every day after that. This time will vary
each day so that the Module doesn't go on at the same time each day (to give your
home a lived-in look).
You can mix Once, Daily, and Security events for the same Unit Code (up to the 64
maximum events for all 8 unit codes). See note at bottom of Setting something to
happen every day at the same time

Reviewing timer events

buttons is pressed without modifying the current time, and no events are in
memory for that module, 0:00 is displayed.
14
Set the Mode Switch in the "Prog Set/Review" position. If no
events exist in memory 0:00 is displayed, otherwise the first event
found in memory is displayed.
If (while in Prog/Review Mode) one of the 4 module ON (or OFF)
© MARMITEK