Drive Pedal; Brake Pedal; Parking Brake - Viking MR 4082 Manuel D'utilisation

Move driver's seat (2) to the desired
position and then release the driver's seat
adjustment lever again.
Ensure that the driver's seat adjustment
lever fully engages in the selected position
when released.

8.8 Drive pedal

Note
Before actuating the drive pedal,
ensure that the correct driving
direction is selected at the driving
direction selector lever.
If the parking brake is engaged or
the brake pedal is pressed, the
drive pedal cannot be actuated.
The driving speed can be
continuously regulated via the
drive pedal.
Stopping:
Take foot off the drive pedal (self-
propulsion) (1).
Reducing the driving speed:
Reduce pressure on the drive
pedal (1).
0478 193 9902 A - EN
Increasing driving speed:
Press down drive pedal (1).

8.9 Brake pedal

The machine can be braked when driving
and can be blocked at a standstill via the
brake pedal.
Press brake pedal (1).
The more firmly brake pedal (1) is pressed,
the more the rear wheels are braked.
Warning:
Never operate the machine with a
defective brake.
Always have a defective brake
repaired or adjusted by a specialist
dealer.
VIKING recommends VIKING
specialist dealers.
Never try to service the brakes
yourself.

8.10 Parking brake

The rear wheels of the machine
are blocked by the engaged
parking brake. This prevents the
ride-on mower from being set in motion
inadvertently (e.g. on slopes, etc.).
Note
Always check the function of the
brakes before engaging the parking
brake.
Engaging the parking brake
Press the brake pedal (1) down to the stop
with the foot and hold.
Pull the parking brake (2) upwards.
● Release the brake pedal again. The
parking brake is activated if the brake
pedal remains in the pressed position.
● Release the parking brake lever. This
swings downwards.
– The rear wheels are blocked.
77