Lubrication; Combustion Engine; Gearbox; Storage - Viking MR 4082 Manuel D'utilisation

Masquer les pouces Voir aussi pour MR 4082:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 117
Insert the battery (1). Close the retaining
clasp (2).
● Connect the battery. (
14.20)
● Install the steering column cover.
(
14.18)
Charging the battery:
Risk of injury!
In order to charge the battery using
another charging system, the
battery must be removed.
The specifications on the battery
supplementary sheet and on the
charger must be observed.
● Stop the engine. (
12.3)
● Remove the ignition key and keep it in a
safe place.
● Disconnect the battery. (
● Remove the battery (
14.20) and
charge using a suitable charging
system.
0478 193 9902 A - EN

14.21 Lubrication

Lubricate the two front steering knuckles
via the two grease nipples on the front
axle.
Note
Before lubricating, the front axle
must be unloaded by supporting
appropriately.
The grease nipple must be cleaned
before lubricating, so that no dirt
enters the steering knuckle.
Escaping grease should always be
removed (wiped off) after
lubricating.
Use commercially available
lubricating grease.
Lubricating:
● Stop the engine. (
● Remove the ignition key and keep it in a
safe place.
● Engage the parking brake. (
● Unload the front axle by supporting
(lifting) it.
14.20)
Using a grease gun (not included in
standard equipment), inject grease on
both sides via grease nipples (1) until
small amounts of grease escape from the
steering knuckles.
● Remove escaping lubricating grease.
● Remove support for the front axle.

14.22 Combustion engine

Observe the operating and maintenance
instructions contained in the attached
engine instruction manual.
To achieve a long service life, it is always
particularly important to maintain a
sufficient level of oil and to change the
engine oil and air filter regularly.
12.3)

14.23 Gearbox

For the user, the gearbox is maintenance-
free.
8.10)
During the inspections of the machine by
the specialist dealer, the required
maintenance operations are performed on
the gearbox.

14.24 Storage

● Store the machine in a dry and dust-
free room out of reach of children and
unauthorised persons.
● Any machine faults must be remedied
prior to storage in order to maintain a
safe operating condition.
● Close the fuel cock. (
● Remove the ignition key and keep in a
place where no unauthorised persons,
especially children, can access it.
14.16)
107

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières