Vollrath CAYENNE Série Manuel D'utilisation page 4

3. Hang chain from an appropriate hanging point directly over the area to be
kept warm. Make sure the hanging point is adequate for the total weight of
the unit and chain.
4. Adjust height of the unit making sure it is level and each point is supporting
the weight of the unit evenly.
5. Tighten screws (B) to secure the mounting tabs.
C
A
B
Figure 4. Chain Mount Installation.
R m c
emote ounting of ontRol
NOTE: Installations must be in accordance with National Electrical Code
(NEC) regulations.
Control boxes must be mounted securely to surfaces using proper hardware.
Mount the control box(es) in such a way they will not be bumped or accidently
switched on or off.
A
Figure 5. Control Panel with Switch and Infinite Control.
A
Figure 6. Control Panel with Switches
A
ON/OFF Toggle Switch. Move the toggle switch to the up position
for "ON". Move the toggle switch to the down position for "OFF".
The switch(es) may operate a heating element(s) or light(s).
B
INFINITE HEAT CONTROL. Rotate the INFINITE HEAT
CONTROL off zero "0" to turn control on. Rotate to desired heat.
4 O ' M
peratOr s
C
A
B
( )
s
B
A
A
anual
u i - c m
nit nstallation oRded
o B t c
n oaRd oggle ontRols
A
Figure 7. On Board Toggle Control with Switches
A
ON/OFF Toggle Switch. Move the toggle switch to the up
position for "ON". Move the toggle switch to the down position
for "OFF".
m o
ounting ptions
NOTE: UL requires all cord and plug heat strips, from all
manufacturers be mounted on legs. All heat strips are custom ordered
and therefore cannot be cancelled or returned per Vollrath Terms and
Conditions.
Figure 8. Stainless Steel C-Leg Stand - 13" (33 cm)
Figure 9. Stainless Steel T-Leg Stand -
Adjustable 8 to 15" (22.8 to 38.1 cm)
ounting
A