Lincoln Electric Saf-Fro DIGISTEEL 255C Manuel D'utilisation page 22


Press the Right Button [36] to confirm the file
selection.

The display shows the Load Data Menu from a USB
Memory Stick to User Interface.

Use the Right Knob [36] to highlight the data icon
which will be loaded.
Figure 32.


Press the Right Knob [36] to confirm the data
selection.
Figure 33.


To confirm and load the data from a USB Memory
Stick, highlight the Check Mark icon and then press
the Right Knob [36].
Figure 34.


To exit the USB Menu – press the Left Button [37] or
disconnect the USB Memory Stick from the USB
receptacle.
Settings and Configuration Menu
To access the Settings and Configuration Menu:

Press the Button [37] or Right Knob [36] to get
access of Welding Parameters Bar.

Use the Right Knob [36] to highlight the icon
"Configuration".

Press the Right Knob [36] to confirm the selection.
English
Table 12.
Symbol Description
Set the Memory Limits
Set the Display Configuration
Set the Brightness Level
Lock / Unlock
Job Mode
Set the Language
Restore Factory Setting
View Software and Hardware Version
Information.
Access to the Configuration Menu
Service Menu
Limits
limits of main welding parameters in selected
job. The Operator is able to adjust the
parameter value within specified limits.
Note: The Limits can be set only for the programs stored
in the user memory.
The limits can be set for:

Welding Current

Wire Feed Speed

Welding Voltage

Wave Controls
To set the range:

Enter to the Settings and Configuration Menu.

Use The Right Knob [36] to higlight the "Limits"
icon.
19
Figure 35.
– it allows the operator to set the
English