SEVERIN HV 7184 SEPURO Mode D'emploi page 15

1. Hold the wall mount to the wall, aligned in a vertical position.
2. Use a pencil to mark the holes.
3. Drill the holes (approx. 6 mm Ø).
4. Insert the dowels (included) into the holes.
5. Fasten the wall mount using the screws (included) and check that it is secure.
6. Attach the tools to the wall mount as shown in Fig. I (foldable furniture tool with item no. 7186 & 7187 only).
∙ Information on battery charging can be found in the enclosed
∙ Information on ordering spare batteries can be found in the "Spare parts and accessories" section of these instructions for
use.
Remove any remaining packaging from the appliance and assemble the component parts:
1. push the dust container into the appliance until you hear it click into place.
2. Push the suction tube onto the appliance.
3. Attach the desired tool to the suction tube (see "Operating the appliance").
Selecting tools
∙ Select the tools for the surface to be vacuumed:
Floor tool
With rotating brush roller. For vacuuming carpets, low pile carpets without loose threads and hard floors.
Upholstery tool
With rotating brush roller. For vacuuming upholstery, mattresses, car seats.
Small furniture tool
For vacuuming furniture and sensitive or hard-to-reach areas, such as cleaning space between keyboard keys.
Flexible furniture tool
Foldable. For vacuuming high cabinets, door frames and the like.
Crevice tool
For vacuuming spaces in the sofa and other hard-to-reach areas.
∙ The tools can be used with and without the suction tube.
∙ Always ensure that the surface to be cleaned can withstand the stress of the floor tool or upholstery tool with a powered
brush roller without damage.
Vacuuming
1. Attach the desired tool to the appliance or to the suction tube.
2. Switch on the appliance with the
3. Each time you press the
Press and hold down the
in two minutes.
4. Vacuum the floor.
5. Switch off the appliance with the
6. Empty and clean the dust container (see chapter "Maintaining the appliance").
7. Place the appliance on the wall mount after use.
Installing the wall mount
Charge battery
Assembling the appliance
Operating the appliance
button. The appliance operates in ECO mode.
button the suction mode is changed as follows: ECO→MIDDLE→POWER→ECO.
button for 3 seconds to set the TURBO mode. The appliance will switch to POWER mode
button.
-original instructions for use.
15