Flex FX1171T Manuel De L'utilisateur page 10

WARNING
making any assembly, adjustments or
changing accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
TO ATTACH/DETACH BATTERY PACK
Lock the variable-speed trigger switch OFF
on the tool by placing the direction-of-rotation
(forward/center-lock/reverse) selector in the
center position before attaching or detaching the
battery pack.
To attach the battery pack:
Align the raised rib on the battery pack with the
grooves in the tool, and then slide the battery
pack onto the tool.
NOTICE: When placing the battery pack onto
the tool, be sure that the raised rib on the
battery pack aligns with the groove inside
the tool and that the latches snap into place
properly. Improper attachment of the battery
pack can cause damage to internal components.
To detach the battery pack:
Depress the battery-release button located
on the front of the battery pack, to release the
battery pack. Pull the battery pack out and
remove it from the tool.
INSTALL AND REMOVE BITS
WARNING
loosen or tighten the chuck jaws on the bit.
Friction burn or hand injury is possible if
attempting to grasp the spinning chuck.
WARNING
Your tool is equipped with a keyless chuck to
tighten or release bits in the chuck jaws. The
arrows on the chuck indicate the direction
in which to rotate the chuck body in order to
tighten or release the chuck jaws on the bit.
To install the bit:
a. Lock the variable-speed trigger switch OFF
on the tool by placing the direction-of-rotation
selector in the center position.
Detach the battery pack
from the tool before
(FIG. 2)
Do not turn on the tool
while grasping chuck to
Do not use bits with
damaged shanks.
ASSEMBLY
WARNING
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous
condition leading to possible serious injury.
Fig. 2
Battery-
Release Button
Fig. 3
Keyless Chuck
-10-
Do not attempt to modify
this tool or create
Battery Pack